HEMI BurnBox G1 Line Lock and Light Show Kit by Z Automotive

Line Lock: 

Using one of the cruise contol buttons/lever (depending on vehicle model), the BurnoutBox uses the ABS valves to hold the vehicle with the front brakes so you can hit the gas and do a perfect burnout as long as you wish, with no wear on the rear brakes.

No plumbing required!

This is a perfect alternative to the traditional plumbed-in solenoid type line lock / roll control. Super simple and cannot be detected! Gone are the days of plumbing in external solenoids in the brake system, having to bleed the brakes and run wires through the firewall to a switch.

Light Show:

Using the hi beam stalk and cruise buttons/lever, turn on a light show that flashes the hi/low beams, turn signals, fog lights, brake lights and reverse lights. Perfect for car shows. Will not work if the car is in motion.

Z Automotive Programming Utility (for Windows PCs only) allows you to update firmware, and more.

INSTALLATION IS A SIMPLE MATTER OF PLUGGING IT INTO THE DIAGNOSTIC OBD2 PORT WHICH IS LOCATED UNDER THE DRIVER'S SIDE DASH.

This will work on any of the vehicles listed above, regardless of engine or transmission.

The Burnout Box works on these cars: